Akai DPS16 Operator's Manual page 50

Chapter 2: Recording on the DPS16
•
EQ ON/OFF
• EQ HIGH FREQ
• EQ HIGH LEVEL
• EQ MID FREQ
• EQ MID LEVEL
• EQ MID WIDTH
• EQ LOW FREQ
• EQ LOW LEVEL
3. Use [TRACK SELECT] keys 1–16 on the top panel to select a target TRACK MIX channel.
In the Control View page, use the
(for TRACK MIX channels), and
square (cursor) on the screen indicates the currently selected channel.
: You may also move the cursor to a graphic field for any channel, using the
TIP
4. Move the cursor to the
The selected channel parameter changes its value.
5. In the same way, set the other mix parameters and the parameters for other channels.
TIPS :
• You can use the transport functions and the locate function in Mixer mode in the same way as in Main
mode.
• In Mixer mode, you can use the Channel View page to display all parameters for certain channels. (See
page 70.)
• You can edit mix parameters using the six knobs in the QLMC section. (See page 75.)
38
(equalizer on/off)
(center frequency in the high range)
(boost/cut amount in the high range)
(center frequency in the middle range)
(boost/cut amount in the middle range)
(band width in the middle range)
(center frequency in the low range)
(boost/cut amount in the low range)
<ex.The PAN parameter is selected.>
[INPUT SELECT]
[MASTER]
<ex.TRACK MIX channel 16 is selected.>
field and rotate the [JOG] wheel to change the parameter value.
Value
keys (for INPUT MIX channels),
key (for the master section) to select a channel to control. A
keys
[TRACK SELECT]
[CURSOR] key.