Club Car 2005 Precedent Maintenance And Service page 48

6
WHEEL BRAKE ASSEMBLIES
Brake Shoe Removal, Continued:
7. Remove brake drums and badly worn brake shoes.
7.1. On the back of each brake cluster assembly, locate the heads of two brake shoe retainer pins. It
may be necessary to remove sealant material around the head of each pin.
1
Figure 6-1 Loosen Turnbuckle
7.2. Insert a 1/2 inch x 5/8 inch cold chisel under the head of each pin and shear them off as illustrated
(Figure 6-2, Page 6-2). This will release the shoes from the backing plate, allowing them to pivot
away from the inside of the brake drum, which should then allow the brake drum to be pulled free.
After completing step 8, skip step 9.
NOTE: Although step 8 allows easier access to the brake shoes, it is not imperative to do so in order to
remove the brake shoes.
8. Remove the axle.
8.1. Using 90° snap ring pliers (CCI P/N 1012560), remove the axle retaining ring (1) (Figure 6-3,
Page 6-2).
8.2. Pull the axle shaft (2) from the axle tube (Figure 6-3, Page 6-2).
2
Figure 6-3 Remove Axle Retaining Ring
Page 6-2 2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
BRAKE
CABLES
3
4
2
1
TWO BRAKE SHOE
RETAINER PIN
HEADS
AXLE TUBE
1/2 IN. X 5/8 IN. COLD CHISEL
Figure 6-2 Shoe Retainer Pins
Brake Shoe Removal
BRAKE
DRUM