Club Car 2005 Precedent Maintenance And Service page 177

MOTOR (MODEL EJ4-4001)
Figure 15b-1 Lift Vehicle with Floor Jack
5. Remove both rear wheels.
6. Remove the nut, cup washer, and bushing from the bottom side of the shock absorber. Compress the
shock absorber (pushing upwards) to move it out of the way (Figure 15b-3, Page 15b-3).
7. Remove the nuts and bolts mounting the rear leaf springs to the shackles.
8. To gain easier access to the motor, lower the transaxle as low as it will go. If more room is needed,
remove the jack from beneath the transaxle and allow the springs to rest on the floor (Figure 15b-3,
Page 15b-3).
Figure 15b-3 Lower Axle
9. Remove the four bolts that mount the motor to the transaxle (Figure 15b-24, Page 15b-15). See fol-
lowing CAUTION.
ý
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft in step 9.
Fingers may get pinched when motor disengages.
10. Carefully slide the motor away from the transaxle until the motor spline disengages the input shaft and
remove the motor from the vehicle.
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
JACK STAND
UNDER ALUMINUM
FRAME RAIL
Figure 15b-2 Vehicle Supported on Jack Stands
15B
Motor
Page 15b-3