Instrument Panel Installation; Floor Mat And Retainers - Club Car 2005 Precedent Maintenance And Service

4
BODY AND TRIM

INSTRUMENT PANEL INSTALLATION

1. Position dash assembly (1) on vehicle. Make sure tabs on the forward edge engage to front underbody.
Secure assembly in place with three screws (2) (Figure 4-3, Page 4-5). Tighten screws to 8.8 ft-lb
(12 N·m).
2. Position dash tray (6) in dash and secure with two barrel fasteners (7).
3. Install the instrument panel.
3.1. Connect the electrical connector on the instrument panel to the harness connector.
3.2. Position the instrument panel (3) on the dash assembly. Make sure tabs on upper edge properly
engage with the corresponding slots on the dash assembly. Ensure that there are no wires exposed
or pinched during positioning.
3.3. Secure instrument panel to the dash assembly with screws (4 and 5). Tighten screws to 1.8 ft-lb
(2.5 N·m).

FLOOR MAT AND RETAINERS

See General Warnings, Section 1, Page 1-1.
The floor mat retainers secure the floor mat to the vehicle and also provide a clean appearance to the side of
the vehicle. Normally, if only the floor mat (3) needs to be removed, the screws (2) can be loosened slightly to
allow the floor mat to be slid from beneath the retainers (1) (Figure 4-4, Page 4-6).
Page 4-6 2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
3
TO BODY
TRIM CLIPS 4 PLACES
Figure 4-4 Floor Mat Retainer
2
5
1
Floor Mat and Retainers
4