Motor - Club Car 2005 Precedent Maintenance And Service

MOTOR (MODEL 5BC59JBS6365)

MOTOR

See General Warnings, Section 1, Page 1-1.
Motor Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-1.
2. Using two wrenches to prevent posts from turning, disconnect wires from terminals on motor. Label the
wires to ensure proper reconnection.
3. Slightly loosen all the lug nuts on both rear wheels.
4. Place floor jack under transaxle and raise rear of vehicle (Figure 15a-2, Page 15a-3) then place jack
stands under frame crossmember between the spring mount and the side stringer, just forward of each
rear wheel. Lower the vehicle to let the jack stands support the vehicle (Figure 15a-3, Page 15a-3). See
following WARNING.
ý
WARNING
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic
floor jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold
vehicle in raised position. Use approved jack stands of proper weight capacity to support the
vehicle and chock the wheels that remain on the floor. When not performing a test or service
procedure that requires movement of the wheels, lock the brakes.
Figure 15a-2 Lift Vehicle with Floor Jack
5. Remove both rear wheels.
6. Remove the nut, cup washer, and bushing from the bottom side of the shock absorber. Compress the
shock absorber (pushing upwards) to move it out of the way (Figure 15a-4, Page 15a-4).
7. Remove the nuts and bolts mounting the rear leaf springs to the shackles.
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
JACK STAND
UNDER ALUMINUM
FRAME RAIL
Figure 15a-3 Vehicle Supported on Jack Stands
15A
External Motor Testing
Page 15a-3