7
STEERING AND FRONT SUSPENSION
Steering Wheel Removal, Continued:
6.6. Remove the steering wheel bolt (6) and the steering wheel (7) from the steering column (9)
(Figure 7-3, Page 7-3).
5
2
Figure 7-1 Steering Wheel Puller
STEERING WHEEL INSTALLATION
NOTE: To minimize corrosion and to make future removal of the steering wheel easier, apply a small
amount of oil or anti-seize compound to steering shaft before installing the steering wheel.
1. Install the steering wheel (7) on the steering column shaft (9). Be sure to align the match marks placed
on the wheel and steering column in step 4 above (Figure 7-3, Page 7-3).
2. Install the steering wheel bolt (6) and tighten to 13 ft-lb (17.6 N·m).
3. Install the scorecard plate (1).
4. If required, install the plate mounting screws (8). Tighten screws to 16 in-lb (1.8 N·m).
STEERING COLUMN
See General Warnings, Section 1, Page 1-1.
STEERING COLUMN REMOVAL
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-1.
2. Remove the steering wheel as previously instructed.
3. Remove the dash insert, instrument panel, dash assembly, and front bumper. See Section 4 – Body
and Trim.
Page 7-2
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
4
APPEARANCE OF
3
SCORECARD HOLDER
MAY BE DIFFERENT
THAN THAT SHOWN
5
6
1
Figure 7-2 Steering Wheel Puller
Steering Column
6
3
2