Club Car 2005 Precedent Maintenance And Service page 132

12
ELECTRICAL COMPONENTS
Key Switch Removal, Continued:
3. Disconnect the wires from the key switch.
4. From the back of the instrument panel, push down on the retaining tabs surrounding the key switch (4)
and remove the key switch cap (8). Hold the key switch and remove the switch retaining nut (6) from the
outside of the instrument panel. (Figure 12-2, Page 12-2).
BLUE
GREEN
Figure 12-2 Key Switch
Key Switch Installation
1. Position the key switch and flat washer (9) in the instrument panel, then install and tighten the switch
retaining nut (6) to 40 in-lb (4.5 N·m). Install key switch cap (8) in center dash (Figure 12-2, Page 12-2).
2. Connect the blue and green wires to the key switch terminals. Either orientation is correct. See Wiring
Diagrams, Section 11, Page 11-2.
3. Install the instrument panel.
3.1. Connect the electrical connector (3) (Figure 12-1, Page 12-1).
3.2. Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly
engage with the corresponding slots on the dash assembly. Ensure that there are no wires exposed
or pinched during positioning.
3.3. Secure instrument panel to the dash assembly with three screws (1). Tighten screws to 1.8 ft-lb
(2.5 N·m).
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
Page 12-2 2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
8
9
6
Key Switch