Table of Contents
Advertisement
ATU-R130 ADSL Ethernet Router User' s Guide
Field
Config IP Address
and
Net Mask
Use DHCP
Default Route
Status
Action
Adding EOA Interfaces
Follow these instructions to add an EOA interface:
1.
Click the WAN tab, and then click
2.
Click
.
The EOA Interface – Add page displays, as shown in Figure 42.
Figure 41. EOA Interface – Add Page{ XE "EOA Interface – Add page" }{ XE "Pages:EOA Interface -
3.
Select one of the predefined interface names from the EOA Interface drop down list.
4.
From the IPF Type drop-down list, select the level of IP Firewall to be used on this
interface, as defined above.
54
Description
The IP address and network mask you want to assign
to the interface. If the interface will be used for
bridging with your ISP and you will not be using the
ATU-R130 as a router on your LAN, then you do not
need to specify IP information. If you enable DHCP
for this interface, then the Configured IP address will
serve only as a request to the DHCP server. The
actual address that is assigned by the ISP may differ
if this address is not available.
When checked, this setting instructs the device to
accept IP information assigned dynamically by your
ISP' s DHCP server. If the interface will be used for
bridging with your ISP and you will not be routing data
through it, leave this checkbox unselected.
Indicates whether the ATU-R130 should use the IP
address assigned to this interface, if any, as its default
route for your LAN. This can be Enable or Disable.
See Chapter 8 for an explanation of default routes.
A green or red ball will display to indicate that the
interface is currently up or down, respectively. You
cannot manually enable or disable the interface; a red
ball may indicate a problem with the DSL connection.
Icons you can click on to edit (
associated EOA interface.
EOA
in the task bar.
Add" }
) or delete (
) the
Advertisement
Table of Contents
