Setting The Dhcp Mode - CTC Union atu-r130 User Manual

ATU-R130 ADSL Ethernet Router User' s Guide
4. If the interface named eth-0 is not already displaying, select it from the drop-
down list and click
The eth-0 interface specifies that your default Ethernet (LAN) interface{ XE "LAN
interface" } is running DHCP relay for your LAN. Typically, this is the only interface you
need to specify here. If the ATU-R130 has additional interfaces that you want to
perform DHCP relay, you can select and add them.
(You can also delete an interface from the table by clicking
5. Click
A page displays to confirm your changes, and then the program returns to the DHCP
Relay Configuration page.
6. Follow the instructions in "Setting the DHCP Mode" on page 28 to set the DHCP
mode to DHCP Relay.
Setting the DHCP Mode{ XE "DHCP:setting operating mode" }
You should set the DHCP mode only after you have configured DHCP relay or DHCP
server settings. See " Configuring DHCP Server" on page 23 or " Configuring DHCP Relay"
on page 27 for additional instructions.
Follow these instructions to set the DHCP mode:
Click the LAN tab, and then click DHCP Mode in the task bar.
1.
2. From the DHCP Mode drop-down list, choose DHCP Server, DHCP Relay, or
none.
If you choose none, your LAN computers must be configured with static IP
addresses.
3. Click
Click the Admin tab, and then click Commit & Reboot in the task bar.
4.
5. Click
28
.
.
.
to save your changes to permanent memory.
in the right column.)