Scan Params - Motorola MC40 User Manual

•
Picklist - Allows the imager to decode only the bar code that is directly under the cross-hair/reticle (+)
part of the pattern. This feature is useful in applications where multiple bar codes may appear in the field
of view during a decode session and only one of them is targeted for decode.
•
Disable – Disables Picklist mode. Any bar code within the field of view can be decoded (default).
•
Centered - Enables the Picklist mode so that only the bar code in the center of the image is decoded.
This is most useful when used in conjunction with the static and dynamic reticle viewfinder modes.
Note: This mode is only valid for decoder modules that supports a viewfinder. If one tries to set this for
a unsupported decoder then the device would issue an error. (Camera scanner only).
•
Reticle - Enables the Picklist mode so that only the bar code that is directly under the cross-hair
(reticle) is decoded. This is useful when used in conjunction with the static and dynamic reticle
viewfinder modes. (Scan Module Only)
•
LCD Mode - Enables or disables LCD mode. LCD mode enhances the ability of the imager to read bar
codes from LCD displays such as cellphones (Scan Module Only).
•
Disable - Disables the LCD mode
•
Enable - Enables LCD mode.
NOTE When using the LCD mode, a degradation in performance may be observed and the aiming crosshair may
blink until the bar code is decoded.
•
Inverse 1D Mode - This parameter allows the user to select decoding on inverse 1D bar codes.
•
Disable - Disables decoding of inverse 1D bar codes.
•
Enable - Enables decoding of only inverse 1D bar codes.
•
Auto - Allows decoding of both positive and inverse 1D bar codes.
•
Viewfinder Mode - Configures the Viewfinder modes supported for camera scanning.
•
Viewfinder Enabled - Enables only the viewfinder.
•
Static Reticle - Enables the viewfinder and a red reticle in the center of the screen which helps
selecting the bar code (default).

Scan Params

Allows the configuration of Code Id and decode feedback options.
•
Code ID Type - A Code ID character identifies the code type of a scanned bar code. This is useful when
the reader is decoding more than one code type. Select a code ID character to insert between the prefix
and the decoded symbol.
•
Code ID Type None - No prefix (default).
•
Code ID Type Aim - A standards based three character prefix.
•
Code ID Type Symbol - A Symbol defined single character prefix.
•
Decode Audio Feedback - Select an audio tone to sound upon a good decode.
•
Decode Haptic Feedback - Enable the MC40 to vibrate upon a good decode (default - enabled).
MSR Input
Use MSR Input options to configure the MSR Input Plug-in for the profile.
Enabled
Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled.
DataWedge Configuration 4 - 17