Barcode Input; Enabled; Decoders - Motorola MC40 User Manual

Selected Application/Activity
Figure 4-11

Barcode Input

Use the Bar Code Input options to configure the Bar Code Scanner Input Plug-in for the profile.

Enabled

Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled.
Scanner Selection
Configures which scanning device to use for data capture.
•
Auto - Automatically determines the best scanning device. If a Scan Module or Scan/MSR Module is
installed on the MC40, then the 2D imager is selected. Otherwise the camera is selected.
•
Camera Scanner - Scanning is performed with the rear-facing camera.
•
2D Imager - Scanning is performed using the installed Scan or Scan/MSR module.

Decoders

Configures which bar code decoders are enabled or disabled. For best performance disable all unnecessary
decoders.
Touch Decoders. The Barcode input screen appears. A check in the checkbox indicates that the decoder is
enabled. By default the most commonly used decoders are enabled (shown below with an asterisk). The
supported decoders are:
•
UPC-A*
•
EAN-8*
•
Interleaved 2 of 5
•
GS1 DataBar Expanded*
•
PDF417*
•
MicroQR
UPC-E0*
Code 128*
GS1 DataBar*
Datamatrix*
Composite AB
Aztec*
DataWedge Configuration
EAN-13*
Code 39*
GS1 DataBar Limited
QR Code*
Composite C
Maxicode*
4 - 9