Table of Contents
Advertisement
5. Push the lever on the processor socket down and out until it pulls up
freely. Lift the lever until it stands straight up (Figure 5-4). Remove the
processor from the socket. Do not touch or bend the pins.
6. Place the old processor in a piece of conductive foam and store it in an
antistatic package. Save the processor clamp and heat sink.
7. Remove the upgrade processor from its antistatic package; do not touch
or bend the pins.
8. Center the processor over the socket. Take care to align the beveled edge
of the processor (Pin 1) as shown in Figure 5-4, A.
9. With the processor in place, lower it gently, being careful not to bend the
pins. Push the lever on the socket forward until it snaps into place
(Figure 5-4).
Figure 5-4. Installing a Microprocessor Upgrade
10. Replace any add-in boards that were removed.
11. If for any reason you need to reinstall the original processor, do steps 1
through 10 above. Remember to reinstall the original CPU clamp.
5-12
A
Installing and Configuring System Board Options
A
OM04466
Advertisement
Table of Contents
