Table of Contents
Advertisement
Removing a 5.25-inch Device
1. Observe the precautions in "Before You Begin."
2. Disconnect the power and data cables attached to the device.
3. While squeezing the protruding plastic snap-in rails attached to the
device towards each other (Figure 4-12), carefully slide the device out of
the bay.
4. Replace the EMI shield and secure it to the chassis with a screw.
5. Replace the filler panel and secure it to the bezel with two screws.
Removing the System Board
1. Observe the precautions in "Before You Begin."
2. Disconnect all internal cables connected to any add-in boards installed in
the expansion slots.
3. Remove all add-in boards.
4. Disconnect all internal cables connected to the system board.
5. Remove the nine retaining screws and set them aside (Figure 4-13).
6. Carefully pop the board off of the snap-in standoff located near the card
retaining bracket (be careful not to flex the board) and lift the board out
of the chassis (Figure 4-13).
!
CAUTION
Be careful not to scrape any board components. Do not flex
the board. Place the board on a grounded, static-free surface
or in an antistatic protective wrapper.
4-22
Taking Your System Apart
Advertisement
Table of Contents
