Table of Contents
Advertisement
What happens
Setup, can't enter
System halts before
completing POST
6-10
What to do
If you can't enter Setup to make changes, check the jumper that
disables entry into Setup (Chapter 5). If the jumper is set to allow
entry into Setup, you might need to clear CMOS RAM to the
default values (Chapter 5) and reconfigure the system in Setup
(Chapter 3).
This indicates a fatal system error that requires immediate service
attention. Note the screen display and write down any beep code
emitted. Provide this information to your service representative.
Solving Problems
Advertisement
Table of Contents
