Table of Contents
Advertisement
Figure 4-6. Installing an Add-in Board
Removing an Add-in Board
Note
Expansion slot covers must be installed on all vacant slots to
maintain the electromagnetic emissions characteristics of the
system and to ensure proper cooling of the system
components.
1. Observe the precautions in "Before You Begin."
2. Disconnect any cables attached to the add-in board you are removing.
3. Remove the screw that holds the board retaining bracket to the chassis.
4. Hold the board at each end, and carefully rock it back and forth until the
edge connectors pull free. Make sure that you do not scrape the board
against other components.
4-12
OM04179
Taking Your System Apart
Advertisement
Table of Contents
