Table of Contents
Advertisement
Taking Your System Apart
This chapter tells how to take apart and reassemble the major parts of the
system. Chapter 5 describes how to remove and install system board
components.
Before You Begin
•
Be sure to do each procedure in the correct order.
•
The procedures (and warnings) for removing and reinstalling the side
covers are assumed to precede all other procedures described in this
chapter.
•
Set up an equipment log to record the system model and serial numbers,
all installed options, and other information about the system. If you
need this information, it will be easier to consult the log than to open up
and examine the system.
•
You will need a Phillips screwdriver (#2 bit). We recommend that you
use an antistatic wrist strap and a conductive foam pad when working
on the system.
!
WARNINGS
The procedures in this chapter assume familiarity with the
general terminology associated with personal computers
and with the safety practices and regulatory compliance
required for using and modifying electronic equipment.
The power supply in this system contains no user-
serviceable parts. To avoid personal injury or damage to
your equipment, refer repair or replacement of the power
supply to qualified personnel only. All other areas and
components of this system are considered user-accessible.
System Product Guide
4
4-1
Advertisement
Table of Contents
