Pci Configuration Status And Error Messages - Mitsubishi Electric apricot VS660 System Product Manual

PCI Configuration Status and Error Messages

The following PCI messages are displayed as a group with bus, device and
function information.
Message
Floppy Disk Controller Resource Conflict
NVRAM Checksum Error, NVRAM Cleared
NVRAM Cleared By Jumper
NVRAM Data Invalid, NVRAM Cleared
Parallel Port Resource Conflict
PCI Error Log is Full
PCI I/O Port Conflict
PCI IRQ Conflict
PCI Memory Conflict
Primary Boot Device Not Found
System Product Guide
Explanation
The floppy disk controller has requested a
resource that is already in use.
The ESCD data was reinitialized because of
an NVRAM checksum error. Try rerunning the
ICU.
The "Clear CMOS" jumper has been moved to
the ON position and CMOS RAM has been
cleared.
Invalid entry in the ESCD.
The parallel port has requested a resource that
is already in use.
This message is displayed when more than 15
PCI conflict errors are detected. No additional
PCI errors can be logged.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
The designated primary boot device (hard disk
drive, diskette drive, or CD-ROM drive) could
not be found.
6-15