Table of Contents
Advertisement
Boot Speed
Sets the system's boot speed. The options are Deturbo and Turbo. The
default is Turbo. If Turbo is selected, boot-up occurs at full speed. If
Deturbo is selected, the board operates at a slower speed.
Num Lock
Sets the beginning state of the Num Lock feature on your keyboard. The
options are On and Off. The default is Off.
Setup Prompt
Turns on (or off) the "Press <F1> Key if you want to run Setup" prompt
during the power-up sequence. The options are Enabled and Disabled. The
default is Enabled.
Note
This option has no effect on your ability to access the Setup
program. It only toggles the prompt.
Typematic Rate Programming
Sets the typematic rates. The options are Default and Override. The default
is Default. Choosing Override enables Typematic Rate Delay and Typematic
Rate.
Typematic Rate Delay
Sets how long it takes for the key-repeat function to start when you hold
down a key on the keyboard. The options are 250, 500, 750, and 1000
millisecond delays. The default is 250. If Typematic Rate Programming is
set to Default, this option will not be visible.
Typematic Rate
Sets the speed at which characters repeat when you hold down a key on the
keyboard. The higher the number, the faster the characters repeat. The
options are 6, 8, 10, 12, 15, 20, 24, and 30 characters per second. The default
is 6. If Typematic Rate Programming is set to Default, this option will not be
visible.
3-10
Using the Setup Program
Advertisement
Table of Contents
