On-Board Video Graphics Controller - Mitsubishi Electric CX series Owner's Handbook Manual

Note
Computer systems that have an unshielded cable attached to a USB
port may not meet current international RFI/emissions requirements,
even if no device or a low-speed USB device is attached to the cable.
Use a shielded cable that meets the requirements for a full-speed USB
device. If in doubt, consult your supplier or the device manufacturer.

On-board video graphics controller

The on-board ATI Rage Pro 2x graphics controller provides these
features:
















Supports isochronous and asynchronous transfer types over the
same set of wires
Bandwidth and low latencies appropriate for telephony, audio,
and other applications
Error-handling and fault-recovery mechanisms built into the
protocol
1x (66MHz) and 2x (133MHz) fully pipelined operation and
sideband support
Full bus mastering support
Triple 8-bit palette DAC with gamma correction (pixel rates
up to 230MHz)
Supports DDC1 and DDC2B+ for plug and play monitors
Game acceleration
DirectDraw, double buffering, virtual sprites, transparent blit,
masked blit, and context chaining
4KB on chip texture caching
Direct3D texture lighting
4MB of 100MHz SGRAM on board
including support
OWNER'S HANDBOOK
M o t h e r b o a r d
for: Microsoft
5/5