Gateway E-420 Maintaining & Troubleshooting page 62

Slide the new drive into the cage and attach the drive to the cage with
7.
four screws.
Slide the drive cage into the chassis, making sure to hook the tabs on
8.
the cage into the slots on the chassis. Replace the three screws that
attach the cage to the chassis.
Slots
Connect the cables to the drives in the cage. If a card guide is included
9.
in your system, replace the add-in card guide and any add-in cards you
removed.
Tab
Important!
When you reinstall the
middle drive cage, make
sure you do not set the
cage on the cables
attached to the control
panel.
System Components 51