Gateway E-420 Maintaining & Troubleshooting page 37

26 Maintaining and Troubleshooting Your E-4200 System
Pull the processor up and out.
B.
Top
bracket
Push the new processor into the slot until it is fully seated.
C.
Place the top bracket over the processor and replace the two screws.
D.
If your processor is attached by a bottom bracket:
7.
Remove the DIMMs on the system board that block access to the
A.
bottom processor bracket. Gently push out the plastic socket clamps
on each end of the DIMMs. Then carefully lift the DIMMs out of
their sockets. Store the DIMMs in static-free bags.