Gateway E-420 Maintaining & Troubleshooting page 54

Slide the bracket up to unhook the tabs on the bracket from the slots in
6.
the chassis. Lift the bracket out of the chassis.
If you are replacing a hard drive, remove the screws that attach the
7.
drive to the drive cage and remove the drive.
Slide the new hard drive into the bracket and attach the drive to the
8.
drive cage.
Replace the hard drive cage in the chassis, sliding it down until the
9.
tabs on the bracket hook into the slots on the chassis. Attach the
bracket to the chassis with the three screws you removed in step 5.
Replace the stability bar.
10.
Connect the power and controller cables to the drives in the bracket.
11.
Replace the system cover (see "Replacing the cover" on page 9 for
12.
instructions). Plug in the power cord and turn on the computer.
Configure the drive as needed in Setup.
13.
If the system does not recognize the new drive, see "Hard disk
problems" on page 73 for troubleshooting information.
System Components 43