Setup, Measure And Record - Leica TPS1200+ Field Manual

5

Setup, Measure and Record

Description
Setup step-by-step
Measure and
record
step-by-step
Setup, Measure and Record
• The Setup application program is used to define the job settings and to set up
and orient the instrument. The routine is accessible from each application
program.
• Independent of the chosen Setup application program method, the job settings
can be defined in the Begin screen of any application program by moving the
focus to <Job:> and pressing ENTER.
The quickest setup method is described. Refer to "TPS1200+ Applications Field
Manual" for further details on additional setup methods.
Step Description
PROG highlight Setup and ENTER to access SETUP Station Setup
1.
Begin.
CONT (F1) to access SETUP Station Setup.
2.
SETUP Station Setup
3.
Select the job which contains the fixpoints. <Fixpoint Job:>.
Select the setup method. <Method: Set Azimuth:>.
Select the source for the station coordinates. For <Station Coord: From
4.
Job> and <Station Coord: Frm Fixpoint Job> CONT (F1) to access
SETUP Select Station.
Type in <Station ID:> and <Instrument Ht:>
5.
CONT (F1) to access SETUP Set Stn & Ori - Set Azimuth.
6. Aim at the target point and enter the Azimuth and Backsight ID. A distance
to the target point may also be measured.
7. Enter the height of the target point.
8. Decide whether all angle measurements at the station are to be updated.
Az=0 (F4) to set the azimuth to 0.000.
SET (F1) to set station and orientation.
9.
The SURVEY Survey: Job Name screen can be accessed from many application
programs where point measurement is required. The ALL (F1), DIST (F2) and REC
(F3) keys are used for measuring and storing the point data. The measurement
settings depend on the current configuration set.
Step Description
1. Refer to paragraph "Setup step-by-step" for information on how to set up
the instrument.
Select Main Menu: Survey.
2.
SURVEY Survey Begin
3.
CONT (F1) to access SURVEY Survey: Job Name, Survey page.
TPS1200+
29