Rear Drive Shaft Service - Polaris Sportsman 400 Service Manual

Hide thumbs Also See for Sportsman 400:

Table of Contents

REAR DRIVE SHAFT SERVICE

1. Remove clamps from rubber boot(s) using the

proper boot clamp pliers.

CV Boot Clamp Pliers:

Earless Type

2. NOTE: Photo at right is shown without shaft for

clarity. Wipe grease away from recess in CV joint

inner hub to locate snap ring.

3. Open the snap ring using a snap ring pliers or small

needle nose pliers. Tap CV housing off shaft with a

soft faced hammer while holding snap ring open.

- projex@inbox.lv -

Tap CV Housing

Snap ring located in

recessed area

Spread ends of snap ring

to remove joint from shaft

Show Quick Links

Table of Contents