Polaris Sportsman 400 Service Manual page 290

FRONT OUTPUT HOUSING ASSEMBLY, CONT.
2. Install shaft with bearing in front output housing.
3. Turn housing, shaft, and bearing assembly over and
install front bearing until fully seated.
4. Front output shaft end play must be measured and
adjusted if shaft or housing was replaced.
To measure end play:
Install snap ring on shaft without shims in place.
Clamp housing lightly in soft jawed vise.
5. Set up a dial indicator to measure shaft end play.
- projex@inbox.lv -
TRANSMISSION
Transmission
Bearing
End of Housing
Shaft
8.21