Oven Lamp Glass And Bulb; Oven Lamp Assembly - Fisher & Paykel Titan AeroTech OD302-B Service Manual

Service Manual 599337A: 302B Series Titan Oven
Follow the reassembly procedure. (refer to Section 7.5)

7.13 Oven Lamp Glass and Bulb

Location: Oven cavity back corners and top of the oven cavity opening.
Removal
1. Remove the glass cover by swivelling the
retaining tab upward to clear the edge of
glass.
Note: The retaining tabs are designed to be
swivelled using a flat head screwdriver.
2. Remove the faulty bulb.
Caution: Do not handle halogen bulbs with
bare hands. Use gloves or a cloth rag.
Reassembly
Refit in reverse manner.
Note: Ensure the glossy side of the glass cover is facing the inside of the oven
cavity.

7.14 Oven Lamp Assembly

Location: Rear corners and top, front of the
oven cavity
For Rear Lamp Assemblies
Removal
1. Follow the general servicing instructions for
components in the back panel area. (refer to
Section 7.3)
2. Remove the lamp cover and bulb. (refer to
Section 7.13)
3. Remove the lamp body retaining screws and
the lamp holder retaining screws.
4. Disconnect the lamp assembly wires at the
connectors in the back panel area.
5. Pull the lamp assembly wires out through the oven cavity.
Note: String can be tied on the end of the light assembly wires to aid in feeding the
new wires back through the holes in the side insulation panel.
Reassembly
1. Feed the new wire connectors back through the hole in the side insulation panel.
2. Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)
52
July 2006
Flat head
Screwdriver
Swivelling
Retaining
Tab
Figure 7.13
Lamp Holder
Retaining Screws
Figure 7.14a