Removal Of The Fan Element; Removal Of The Oven Lamp Cover & Bulb - Fisher & Paykel DCS WOSV230 Service Manual

8.11 Removal of the Fan Element

1. Ensure the product is isolated from the
power supply
2. Remove the oven doors and racks
3. Remove the fan shroud. Refer to Section 8.9
on pg. 56.
4. Remove the 3 screws from the element and
retaining bracket
5. The element tail will pull through far enough
to remove the wiring
6. Refit new element and reassemble in reverse
order
8.12 Removal of Oven Lamp Cover & Bulb
1. Remove the oven door and racks to gain
access to the side lamp covers
2. Use a small flat-head screwdriver to twist
and lift the retainer clip at the top of the
glass light cover while holding the glass to
prevent it falling. The clip pivots counter-
clockwise (see the diagram).
3. Carefully lift the glass cover out of the lower
support and pull out the faulty bulb
4. Holding the replacement bulb in a soft cloth
or tissue (touching the bulb will reduce its
life span), insert the new bulb
5. Reposition the glass cover and twist the top
clip back in place. The procedure is the same
for the light in the roof of the oven cavity.
Retainer clip
Sockets for
the pins
Plate glass cover
Pins
Replacement bulb
57