Fisher & Paykel Titan AeroTech OD302-B Service Manual page 53

Service Manual 599337A: 302B Series Titan Oven
For Front Lamp Assembly
Removal
1. Follow the general servicing instructions for components in the control panel area.
(refer to Section 7.2)
2. Remove the lamp cover and bulb. (refer to Section 7.13)
3. Disconnect the lamp assembly wires from the terminal block in the top panel area.
4. Remove the control panel. (refer to Section 7.2)
5. Remove the three screws along the front of the wiring panel and the two screws either
side fixing the wiring panel.
6. Lift the front of the wiring panel to access the lamp assembly and wires.
7. Remove the lamp holder retaining screws.
8. Feed the wires through the hole in the wiring panel.
Reassembly
1. Refit in reverse manner.
2. Follow the reassembly procedure. (refer to Section 7.5)
Wiring Panel
Remove 5
Screws
Figure 7.14b
53
July 2006