Fisher & Paykel Titan AeroTech OD302-B Service Manual page 55

Service Manual 599337A: 302B Series Titan Oven
Bake element
Location: Under the oven cavity
Removal
1. Follow the general servicing instructions for components in
the back panel area. (refer to Section 7.3)
2. Remove the two largest vent ducting sections.
For Single Ovens and Double Oven Lower Cavity
1. Remove the two screws on the bake element cover.
2. Bend the element cover down to clear the element.
3. Remove the element wires.
4. Remove the element retaining screw.
5. Pull the element out from under oven cavity.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)
For Double Oven Upper Cavity
1. Remove the remaining section of vent ducting.
2. Disconnect the lower vent fan wires.
3. Remove the lower vent fan.
4. Remove the element wires.
5. Remove the two screws retaining the fan cover.
6. Pull the fan cover with the cooling fan attached upward to clear
the locating tabs.
7. Allow the fan cover to drop down to clear the element.
8. Remove the element retaining screw.
9. Pull the element out from under the oven cavity.
Reassembly
Refit in reverse manner.
Note: When reinserting the element, use a wide flat blade or similar object, to lift the
cavity insulation clear of the replacement element.
Follow the reassembly procedure. (refer to Section 7.5)
Fan cover screws
Figure 7.15b
55
July 2006
Largest
Ducting
Sections
Bake
Element
Cover
Screws
Figure 7.15a