Oven Cavity Fan; Fan Shroud - Fisher & Paykel Titan AeroTech OD302-B Service Manual

Service Manual 599337A: 302B Series Titan Oven
4. Remove the vent fan wires and transfer them to the replacement fan.
5. Separate the vent fan from the vent tube.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)

7.18 Oven Cavity Fan

Location: Back panel area
Removal
1. Follow the general servicing instructions for components around the back panel area.
(refer to Section 7.3)
Note: If the oven fan is not operating, check to see if the fan element is operating
correctly. The element will burn out if it has no cooling air supply.
2. Disconnect the wires to the fan motor.
3. Remove the oven fan shroud. (refer to Section 7.19)
4. Remove the oven fan blade.
Note: Turn the fan blade securing nut clockwise to remove (left hand thread).
5. Remove the three fan motor mounting screws
and remove the fan motor from the rear.
6. Transfer
replacement fan motor.
Note: To remove the mounting plate use pliers
to bend the holding tabs.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to
Section 7.5)

7.19 Fan Shroud

Location: Rear wall of oven cavity
Removal
1. Remove the utensils, shelves and runners. (refer to section 7.20)
2. Remove the two screws securing the top of the shroud.
Note: Hold the shroud when removing screws as it will fall forward.
3. Remove the shroud from the two tongue slots at the bottom of the oven cavity.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)
the mounting plate to the
57
July 2006
Figure 7.18