Components In Back Panel Area; Components In Service Panel Area; Reassembly Procedure - Fisher & Paykel Titan AeroTech OD302-B Service Manual

Service Manual 599337A: 302B Series Titan Oven

7.3 Components in Back Panel Area

1. Remove the oven from the joinery cavity. (refer to Section 7.1)
2. Remove the six rear-most screws on the top panel.
3. Remove the two screws fixing the cable connector panel to the back panel.
4. Remove the back panel screws and lift off the back panel.
Components at the back of the oven will now be accessible.
Reassembly
1. Refit in reverse manner.
2. Follow the reassembly procedure. (refer to Section 7.5)

7.4 Components in Service Panel Area

1. Remove from the joinery cavity. (refer to Section 7.1)
Warning! To avoid the oven tipping forward, remove shelves, utensils and doors. (Refer
to Section 7.21)
Note: The oven does not need to be removed completely from the joinery cavity. Sliding
the oven out 8 inches (200mm) will give sufficient access space.
2. Remove the two screws fixing the service panel to the side panels.
3. Lift off the service panel.
The power module and other electronic components will now be accessible.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)

7.5 Reassembly Procedure

1. After repairing or replacing components, ensure that all wiring terminals are correct
and tight.
Diagnostics Section 4.3)
2. Disconnect the power supply and refit panels.
3. Slide the oven back into the joinery cavity and refit the four securing screws.
4. Refit the oven doors, shelves and utensils.
5. Restore the power, reset the clock and check the oven modes.
Restore power and test repaired or replaced components.
46
July 2006
(refer to