Oven Temperature Sensor; Oven Lamp Glass And Bulb; Oven Lamp Assembly - Fisher & Paykel Titan aerotech OD301US Service Manual

7.12 Oven Temperature Sensor

Location: Oven cavity rear top left corner.
Removal
(a) Remove oven fan shroud (Refer to Section 7.19)
(b) Remove two screws securing the sensor to the oven cavity.
(c) Pull sensor wires through hole in oven cavity wall until wire connector is
accessible.
(d) Disconnect faulty sensor and connect replacement.
Re-assembly
(a) Push excess wire back through hole in oven cavity.
(b) Re-fit in reverse manner.
(c) Follow re-assembly procedure (Refer to Section 7.5).

7.13 Oven Lamp Glass and Bulb

Location: Oven cavity back corners and top of oven cavity opening.
Removal
(a) Remove glass by swivelling retaining tab
up to clear edge of glass.
The glass will now drop out.
Note: Retaining tabs are designed to be
swivelled using a flat head screwdriver.
(b) Pull
replacement.
Note: Do not handle bulbs with bare hands. Use gloves or a cloth rag.
Re-assembly
(a) Re-fit in reverse order.
Note: Ensure frosted side of lamp glass is facing side of oven cavity.

7.14 Oven Lamp Assembly

Location:
For Rear Lamp Assemblies
Removal
(a) Follow general servicing instructions for
components in back panel area. (Refer
to Section 7.3).
(b) Remove lamp glass and bulb. (Refer to
Section 7.13)
(c) Remove two lamp assembly retaining
screws.
out faulty bulb
Oven cavity back corners and top of oven cavity opening.
and insert
- 53 -
Flat head
Screwdriver
Swivelling
Retaining
Tab
Lamp Assembly
Retaining Screws