Power Module - Fisher & Paykel Titan AeroTech OD302-B Service Manual

Service Manual 599337A: 302B Series Titan Oven

7.9 Power Module

Location: Under the service panel
Removal
1. Follow the general servicing instructions for components around the service panel
area. (refer to Section 7.4)
2. Remove all wires and wire harnesses and transfer them to the replacement power
module. (refer to Technical Overview Section 2.25)
Note: Label the relay switch wires before removing them to ensure the correct
connections are made to the replacement power module.
3. Lift the power module off the seven P.C.B stand-offs.
Note: Use a small pair of needle-nose pliers to
force in the plastic barbs on the P.C.B stand-offs
in order to lift the board up.
Re-assembly
Refit in reverse manner.
Follow the reassembly procedure.
Section 7.5)
(refer to
49
July 2006
Figure 7.9a