Servicing The Components; Removal From The Joinery; Removal Of The Door; Disassembly Of The Door - Fisher & Paykel DCS WOSV230 Service Manual

WARNING!
Ensure the product is isolated from the power supply before servicing. Follow the health and safety
precautions while servicing.

8.1 Removal From the Joinery

1. Ensure the product is isolated from the power supply
2. Remove the oven doors, shelves and utensils
3. Remove the two screws on either side of the oven frame that secure the oven to the joinery
4. Slide the oven out of the cabinet onto a suitable support that is capable of holding the weight of
the product
WARNING! This oven is heavy and care should be taken to use correct lifting techniques.

8.2 Removal of the Door

Removal
1. Open the oven door to its fully open position
(90° to oven)
2. Pull the hinge clips on the lower arm of the
hinges forward until they lock onto the upper
arm
3. Raise the door, ensuring the clips load the top
arm of the hinges
4. Lift the oven door out of the hinge slots
Reassembly
1. Place the hinge arms into the hinge slots ensuring
they lock into place
2. Ensure the oven door is opened fully, unlock the
upper arm from the hinge clips
3. Raise the door slightly and ensure the hinge clips
are released from the upper arms
4. Check the door closes and seals correctly

8.3 Disassembly of the Door

To separate door inner and door outer assemblies
1. Remove the door from the oven (refer to 8.2
above)
2. Lay the door face down on a flat, clean working
surface.
3. Remove the four hinge screws on the bottom
of the door and the eight retaining screws down
the sides of the door.
4. Separate the inner and outer door assemblies.

8 SERVICING THE COMPONENTS

Hinge clip
unlocked
Locked
Screws
49