Carburetor Removal - Honda GX690 Workshop Manual

CARBURETOR REMOVAL/

INSTALLATION
Gasoline is highly flammable and explosive.You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Remove the air cleaner (page 6-3).
Attach a commercially available tube clamp to the fuel
tube.
Disconnect the fuel tube from the carburetor.
Loosen the carburetor drain screw and drain the float chamber completely.
FUEL TUBE GROMMET STAY
INSTALLATION:
Install the fuel tube grommet
stay (1) in contact with each
projection (2) of stay and inlet
manifold (3).
(3)
(1)
(2)
INLET MANIFOLD
GOVERNOR ROD/THROTTLE
RETURN SPRING
REMOVAL:
Unhook the throttle return spring (1)
from the carburetor throttle linkage
(2). Then push off the carburetor
throttle linkage to unsnap from the
governor rod (3).
Disconnect the governor rod from
the throttle linkage.
(2)
(3)
(2)
BREATHER TUBE
CARBURETOR
PACKING
CARBURETOR
INSULATOR
(3)
BOLT
(6 x 50 mm)
(4)
(1)
AIR CLEANER CASE SEAL
BREATHER
TUBE CLIP
AIR CLEANER PACKING
FUEL SYSTEM
BOLT(6 x 106 mm) (4)
AIR CLEANER
ELBOW
CARBURETOR
INLET MANIFOLD
PACKING
6-5