STARTING SYSTEM
SYSTEM DIAGRAM
STARTING SYSTEM
ST
BAT
COMBINATION
SWITCH
STARTING SYSTEM
TROUBLESHOOTING
STARTER MOTOR DOES NOT OPERATE
Check the battery condition.
Good
Check the battery voltage between the starter
motor side positive (+) battery cable terminal
and engine ground.
Good
Check the continuity between BAT terminal
(W) and ST terminal (Black/white) of the
combination switch in the START position
(page 11-4).
Continuity
Check the blade fuse in the control box (page
11-4).
Not blown
Check the magnetic switch (page 10-6).
Good
Perform the starter motor performance test
(page 10-5). If necessary disassemble the
starter motor (page 10-4) and check the each
parts (page 10-6, 7).
10-2
Bl/W
W
FUSE
(30 A / 40 A)
No good
Replace with a known-good battery.
If the battery runs out again, perform the
CHARGING SYSTEM
TROUBLESHOOTING (page 8-3).
Low voltage
Replace battery positive (+) cable.
No continuity
Replace the combination switch (page 7-10).
Blown
Replace the blade fuse.
No good
Replace the magnetic switch (page 10-4).
Bl/W
W
BATTERY
STARTER
MOTOR