OTHER ELECTRICAL
COMBINATION SWITCH INSPECTION
Remove the combination switch (page 7-10).
Check continuity between the terminals at each switch
position.
If the correct continuity is not obtained, replace the
combination switch (page 7-10).
Disconnect the charge coil connectors and combination
switch 4P connector (1). Remove the combination
switch 4P connector, and open the wire harness clip (2)
to remove the wire harness.
Remove the special screw (3) and the control cover (4).
Remove the blade fuse (5) from the fuse box (6).
Visually inspect the blade fuse.
Check continuity between the blades of the fuse.
If there is not continuity, replace the blade fuse.
11-4
GND
LO
GND
(Bl/Y)
(G)
IGN
(Bl)
IGN GND
BAT
OFF
ON
ST
(6)
(5)
(4)
Blown
BAT
ST
BAT
LO
(Bl/Y)
LO
ST
(1)
(3)
(2)