Configuring Network Settings
Assigning the NTP Server
Step 1
Step 2
Step 3
Step 4
Step 5
Enabling CDP
Step 1
Step 2
Step 3
Step 4
Step 5
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
5-12
If you choose to use an NTP server to synchronize the time settings on the
DPA 7630/7610 (see
"Identifying the Time Source for Event Logs" section on
page
5-10), you must assign an NTP server and designate its time zone.
To set the NTP server, perform these steps:
From the main menu, choose Configure.
Choose Network interface.
Choose NTP server.
Enter the IP address of the NTP server.
Note
If you are using DHCP to obtain an IP address on the DPA 7630/7610, the
DHCP server should also indicate the NTP server.
Restart the DPA 7630/7610.
The DPA 7630/7610 can advertise itself to other network devices using
Cisco Discovery Protocol (CDP). Many network management applications
require that CDP is enabled.
To enable CDP, perform these steps:
From the main menu, choose Configure.
Choose Network interface.
Choose CDP.
Press Enter to toggle between enabled and disabled.
Restart the DPA 7630/7610.
Chapter 5
Getting Started with the DPA 7630/7610
78-11069-03