Cisco DPA 7630 Administration Manual page 44

Using the Hybrid Integration Mode
Figure 2-5 Logical Connections of Hybrid Integration on the DPA 7630
Definity or Meridian 1 PBX
1
Line C
(Ports 24-17)
Assign these 4 lines to
1
set MWIs on the Definity
or Meridian 1 PBX.
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
2-10
2
Line B
(Ports 16-9)
DPA 7630
Assign these 4 lines to
2
handle MWI commands.
Use the same number of
lines and corresponding
ports as those on Line C.
Follow these guidelines when configuring the DPA 7630:
Line A (ports 1-8) connects to the Octel system and handles call processing.
•
You can designate each line to handle incoming or outgoing messaging, but
a single line cannot support both.
Line B (ports 9-16) connects to the Octel system. A portion of these lines can
•
be used for call processing (as with Line A), but all MWI lines must connect
through Line B. So, if you have n MWI lines, you have 8-n available for
incoming messages on ports 9-16 (in addition to the 8 ports available on Line
A).
Also, ensure the MWI lines have a one-to-one correspondence with the MWI
lines in Line C, in both quantity and physical location. For example, if you
assign the last four ports on Line B (ports 13, 14, 15, and 16) to be Octel MWI
lines, you must also assign the last four ports on Line C (ports 21, 22, 23, and
24) to be Definity MWI lines.
Chapter 2 Choosing an Integration Mode
Octel
3
Line A
(Ports 8-1)
Assign these 12 lines to
3
handle either incoming
calls or outgoing calls.
Do not enable incoming
and outgoing calls on the
same line.
78-11069-03