Enabling Mobile Client Service Abstraction - Cisco Intelligent Wireless Access Gateway Configuration Manual

Overview of the Intelligent Wireless Access Gateway
SUMMARY STEPS
1. enable
2. configure terminal
3. interface GigabitEthernet slot/subslot/port
4. description string
5. ip address ip-address mask [secondary [vrf vrf-name ]]
6. negotiation auto
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3
interface GigabitEthernet slot/subslot/port
Example:
Router(config)# interface GigabitEthernet 1/3/5
Step 4 description string
Example:
Router(config-if)#description interface connected
to GGSN
Step 5
ip address ip-address mask [secondary [vrf vrf-name ]]
Example:
Router(config-if)# ip address 192.170.10.1
255.255.0.0
Step 6 negotiation auto
Example:
Router(config-if)# negotiation auto

Enabling Mobile Client Service Abstraction

This section describes how to enable Mobile Client Service Abstraction (MCSA) for PMIPv6.
OL-30226-03
Configuring the iWAG for 3G Mobile IP Users
Purpose
Enables the privileged EXEC mode.
Enter your password, if prompted.
Enters the global configuration mode.
Enters the interface configuration mode for Gigabit
Ethernet interface.
Adds a description to an interface configuration.
Sets a primary IP address or secondary IP address for
an interface.
Enables auto negotiation on a Gigabit Ethernet
interface.
Intelligent Wireless Access Gateway Configuration Guide
17