Event And Error Messages - KERN ITS Operating Instruction

ITS-BA-e-0720

6 Event and error messages

Error
Display Dark
Insufficient load
Overload
User manual ME-Nr.:22017077 01/07
Cause
•
Back lighting set too dark
•
No mains voltage
•
Unit switched off
•
Mains cable not plugged in
• Brief fault
•
Load plate not on the scale
•
Weighing range not reached
•
Weighing range exceeded
•
Result not yet stable
•
Function not permissible
•
Zeroing not possible with over-
load or insufficient load
•
Average piece weight too low
•
No valid value from the reference
scale
• No calibration
•
Average piece weight too low
Event and error messages
Remedy
➜ Set back lighting (b.LIGHt)
brighter
➜ Check mains
➜ Switch on unit
➜ Plug in mains plug
➜ Switch device off and back on
again
➜ Place load plate on the scale
➜ Set to zero
➜ Unload scale
➜ Reduce preload
➜ If necessary adjust vibration
adapter or weigh dynamically
➜ Unload scale and set to zero
➜ Unload scale
➜ Select and place larger number of
reference parts on the scale
➜ Check cable connection between
the units
➜ Check interface settings
➜ Unplug the mains plug then plug
it back in; switch unit off and then
back on in battery mode
➜ Calibrate scale
➜ Contact your dealer or local rep-
resentative
➜ Counting is not possible on this
scale with this average piece
weight
42