Table of Contents
Advertisement
4.6.3
bAUd
PAritY
H.SHAKE
NET.Addr
ChECSuM
Vcc
4.6.4
SUrE?
4.6.5
EtH.NEt
IP.AddrS
SUBNEt
GAtEWAY
USb
USb TEST
diGitAL
IN 1 ... 4
OFF
ZErO
tArE
PriNt
rEF 10
rEF n
SCALE
UNIt
COM1/COM2 -> PARAMET – communication parameter
Selecting baud rate: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400 baud
Selecting parity: 7 none, 8 none, 7 odd, 8 odd, 7 even, 8 even
Selecting Handshake: NO, XONXOFF, nEt422, nEt485 (network operation
as per RS485 standard via the optional RS422/RS485 interface, only for COM1)
Assigning network address: 0 ... 31, only for NET 485
Activating checksum byte (appears only in TOLEDO Continuous mode)
Switching 5V voltage, e.g. for a bar code reader, on / off
COM1/COM2 -> RESET COM1/RESET COM2 – resetting serial interface to factory
settings
Confirmation inquiry
•
Reset interface settings to factory settings with
•
Do not reset the interface settings with
OPTION – configuring options
If no option is installed or is not yet configured, N.A. appears in the display.
Configuration of the Ethernet interface
•
Enter IP address
•
Enter Subnet address
•
Enter Gateway address
not documented
Advertisement
Table of Contents
