Table of Contents
Advertisement
Support
Troubleshooting
What happens if the clock doesn't power up?
Make sure the wiring is correct. If the clock is 120VAC, the power should be on the black and white wires. The middle (green) wire is ground. If
the wiring is correct, take a volt meter and measure the voltage. For 120VAC models, the voltage should read 85 - 135 volts.
What happens if the clock does not receive the signal?
Take the clock within close proximity to the transmitter and power the clock. If the clock does not correct, call Valcom technical support.
I have a location with a marginal signal. What should I do?
Try to install a repeater in a nearby area to the location or install a 120VAC clock.
+1 540-563-2000 P.
Valcom, Inc.
+1 540-362-9800 F.
5614 Hollins Road
www.valcom.com
Roanoke, VA 24019
USA
11
Advertisement
Table of Contents
Need help?
Do you have a question about the V-DW11025B and is the answer not in the manual?