Direct Tcp/Ip Connection From Visual Studio - Casio DT-X7 Series Quick Start Manual

5.8 Direct TCP/IP Connection from Visual Studio

If you have a network connection to the DT-X7 (for example, via WLAN or the Ethernet cradle) then
you can establish a direct link to the development PC without using ActiveSync.
For Visual Studio .NET 2003
If network connection has been established between the DT-X7 and the PC that is under the application
development environment, the WindowsCE Utilities add-on pack (described in Chapter 2.3) can be used
to make direct link possible. Refer to the readme file supplied with the add-on pack for detail on how to
set up the connection.
For Visual Studio 2005
1. Download the files listed below from the PC running in Visual Studio 2005 to the DT-X7.
- Clientshutdown.exe
- ConmanClient2.exe
- CMAccept.exe
- DeviceDMA.dll
- eDbgTL.dll
- TcpConnectionA.dll
The source folder in the PC:
C:\Program Files\Common Files\Microsoft Shared\CoreCon\1.0\Target\wce400\armv4i
The destination folder in the DT-X7:
\Windows
2. Run ConmanClient2.exe on the DT-X7.
3. Set the device IP address in Visual Studio 2005.
4. Navigate to Tools in the main menu of Visual Studio 2005 → Options... → Device Tools →
Devices.
5. Choose DT-X7 Device in the pull-down menu of Devices: and click Properties....
6. Click Transport: to access Configure... and set up Device IP address as shown in Figure 5.33.
Figure 5.33
7. Run CMAccept.exe on the DT-X7.
8. Navigate to Tools in the main menu of Visual Studio 2005 → Connect to Device....
50