Casio DT-X7 Series Quick Start Manual page 27

4. Before using the cradle ports, remove the caps from the ports. When using a LAN, connect one end of
the LAN cable to the LAN port and the other end to the PC or hub. When using a USB connection,
connect one end of the USB cable (DT-380USB) to the USB port and the other end to the PC.
Figure 4.9
5. Align the contacts on the underside of the DT-X7 with the power supply contacts on the Ethernet
Cradle and then set the DT-X7 into the cradle so that mount holes in the back of the DT-X7 are
aligned with the mount hooks on the cradle. Once the DT-X7 is properly set in the cradle, the power
LED on the front of the Ethernet cradle lights green.
Figure 4.10
Status of Indicator 1 on DT-X7
Orange : Charging the battery pack.
Red : Standby due to battery pack error or the surrounding temperature is out of range (charging
begins when the temperature is within the correct range.)
Green : Charging the battery pack is complete.
Important notes:
• Always remove the DT-X7 from the Ethernet Cradle before changing the selector switch setting.
• Never short out the power contacts of the cradle. This damages the cradle.
• Do not subject the DT-X7 and cradle to vibration or impact during communication. This results in
communication being interrupted.
• When mounting the DT-X7, securely attach it to the mount hooks of the cradle and check that the
power LED on the front of the cradle lights green. Charging battery pack or communication will not
proceed if it is not mounted properly.
• The LAN and USB connections cannot be used concurrently.
• Always cap ports that are not being used. Using the Ethernet Cradle while the ports are uncapped can
cause damage.
27