Connection Via Ethernet Cradle - Casio DT-X7 Series Quick Start Manual

5.6 Connection via Ethernet Cradle

This chapter describes how to establish a high speed LAN connection on the WLAN non-integrated
models with HA-F62IO Ethernet cradle via ActiveSync 3.8 (see note) or earlier.
Note:
Later versions of the Microsoft ActiveSync do not support this connection. Use version 3.8 or earlier to
establish the connection.
Follow the steps below:
1. Establish partnership first between the DT-X7 and PC using any method so far described in this guide
(connection establishment via IrDA, WLAN, Bluetooth or USB cradle).
2. Connect the dedicated AC adapter to the Ethernet cradle as described in Chapter 4.2.
3. Connect one end of the network cable to the Ethernet cradle and the other end to the network hub.
4. Make sure the selector switch on the left side of the HA-F62IO Ethernet cradle is set to the "LAN"
position. See Figure 5.30 below.
Figure 5.30
5. Place the DT-X7 in the cradle and navigate to Start → Settings → Control Panel → Network
and Dial-up Connections.
6. The following screen will appear. Double click the AX887721 icon. The icon will not appear unless
the terminal is seated in the cradle.
Figure 5.31
Set to LAN
47