Casio DT-X7 Series Quick Start Manual page 46

Table 5.7
Field / Radio Buttons
WLAN configure / WLANConfig /
Status display tool NetSearch
WLANConfig /
NetUI
NetUI / NetUI
Enable adhoc network setting
Enable all authentication settings
Inifile comment
8. If OK button in the popup warning message (see Table 5.7 for description of NetUI/NetUI radio
button) is clicked, the screen in Figure 5.29 appears. Click OK button to perform a reset on the
terminal so that the setting takes effect.
Figure 5.29
9. Check to make sure that the connection has been established using the NetSearch utility, and then
navigating to the Ping function in there. Enter HostName first and then click Ping to check that you
are connected to the network correctly.
Description
- Use only CASIO provided WLAN tool.
- Configure WLAN setting with settings
extracted from the ini file.
- Initiate NetSearch when tapping the icon in
the task tray.
- Use both CASIO provided WLAN tool and
MS tool.
- Configure WLAN setting with settings
extracted from the ini file.
- Initiate NetUI (MS tool) when tapping the
icon in the task tray.
- Use only the MS tool.
- Configure WLAN setting, not with settings
extracted from the ini file.
- Initiate NetUI when tapping the icon in the
task tray.
If this radio button is selected and the OK button
that appears in the subsequent popup warning
message is clicked, other settings in the ini file
will be deleted. Only the WLAN configuration
set with NetUI is saved.
With checkmark : enable the setting.
Without checkmark : disable the setting.
With checkmark : enable the setting.
Without checkmark : disable the setting.
Enter a comment of up to 100 characters to be
written in the ini file.
46
Default
Yes
Yes
Yes
None