Performance Data Sheet - Watts Premier WP-5 Installation, Operation And Maintanance Manual

GENERAL USE CONDITIONS:
1. S
with wate
reduction may be used on disinfected water that may contain filterable cysts.
2. Operating Temperature:
3. Operating Water Pressure:
4. pH
5. No iron present in incoming feed water supply.
6. Hardness of more than 10 grains per gallon (170 ppm) may reduce TFM membrane life expectancy.
7. Recommend TDS (Total Dissolved Solids) not to exceed 1800 ppm.
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVALS:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description
Sediment Pre-filter: #5m-10
Carbon Pre-filter:
Final Carbon filter
R.O. Membrane:
This system has been tested according to NSF/ANSI 58 for reduction of the substances listed below. The concentration of the indicated substances
in water enter
NSF/ANSI 58. This system has been tested for the treatment of water containing pentavalent arsenic (also known as As (V), As (+5), or arsenate)
at concentrations of 0.30 mg/L or less. This system reduces pentavalent arsenic, but may not remove other forms of arsenic. This system is to
be used on water supplies containing a detectable free chlorine residual at the system inlet or on water supplies that have been demonstrated to
contain only pentavalent arsenic. Treatment with chloramine (combined chlorine) is not sufficient to ensure complete conversion of trivalent arsenic
to pentavalent arsenic. Please see the Arsenic Facts section of the Performance Data Sheet for further information.
Avg. In.
Arsenic (Pentavalent) 334.615 ug/L
Barium Reduction 10.2 mg/L
Cadmium Reduction 0.036 mg/L
Chromium (Hexavalent) 0.15 mg/L
Chromium (Trivalent) 0.17 mg/L
Copper Reduction 3.1 mg/L
Cysts 222,077#/ml
Fluoride Reduction 8.0 mg/L
Lead Reduction 0.15 mg/L
Perchlorate 0.10 mg/L
Radium 226/228 25pCi/L
Selenium 0.10
TDS
Turbidity 10.2 mg/L
Model No. Avg.
Influent
TDS
765 mg/l
Depending on water chemistry, water temperature, and water pressure Watts Premier's R.O. Systems production and performance will vary.
Efficiency rating means the percentage of the influent water to the system that is available to the user as reverse osmosis treated water under operating
conditions that approximate typical daily usage. Recovery rating means the percentage of the influent water to the membrane portion of the system that is
available to the
an average of 4 gallons of reject water for every 1 gallon of product water produced.
REFER TO OWNER'S INSTALLATION/SERVICE MANUAL FOR FURTHER MAINTENANCE REQUIREMENTS AND WARRANTY INFORMATION.

Performance Data Sheet

WP-5, KP-5, RO5-M
1725 W. Williams Drive C-20
Phoenix, AZ 85027 USA
(623) 931-1977 wpmail@wattsind.com
Maximum: 100°F (40.5°C)
Maximum: 85 psi (7.0kg/cm2)
2 to 11
#GAC-410-56/#5MCB
#1M-6/#1M-10
#TFM-24
Avg. Eff. % Reduction pH
5.0385 ug/L 98.4%
0.207 mg/L 97.9%
0.0005 mg/L 98.6%
0.013 mg/L 91.3%
.01 mg/L 94.1%
0.03 mg/L 99.0%
10 #/ml 99.99%
0.5 mg/L 93.9%
0.002 mg/L 98.6%
0.003 mg/L 96.5%
5pCi/L 80.0%
0.008 92.0%
765 23 mg/L 96.8%
0.26 mg/L 97.5%
Avg. Avg. TDS DPR
Effluent
TDS
23mg/l
Watts Premier Inc.
Change time Frame
6 Months
6 Months
12 Months
2 to 5 years
Pressure Max Eff.
50psi
7.24 50psi 0.3 mg/L
7.49 50psi
7.24 50psi
7.24 50psi
7.64 50psi
7.49 50psi
7.49 50psi
7.39 50 psi
7.24 50psi
50psi
7.84 50 psi 33 mg/L
IN /EFF RECOVERY
REDUCTION
96.8% 15.5%
Page 22
Minimum: 40° (4.4°)
Minimum: 40 psi (2.8kg/cm2)
Inf. challenge
concentration
mg/L
19 ug/L 0.30±10%
10.0±10%
0.0007 0.03±10%
0.03 0.3±10%
0.01 0.3±10%
0.04 3.0±10%
58 minimum 50,000/mL
0.7 8.0±10%
0.003 0.15±10%
0.005 0.10±10%
5pCi/L 25pCiL±10%
0.011 0.10±10%
750±40mg/L
0.83 11±1 NTU
GALLONS
9.06gpd
. DO NOT use
ed for cyst
ed in
Max Allowable
concentration
mg/L
0.010 mg/L
2.0
0005
0.1
0.1
1.3
1.5
0.010
0.006
5pCiL
0.05
187
0.5 NTU
EFFICIENCY
8.35%
There is