Performance Data Sheet - Watts Premier FILTER-PURE Installation, Operation And Maintenance Manual

Table of Contents

GENERAL USE CONDITIONS:

1: System has been independently tested for the removal of microbiologically contaminated water. The system is not intended

for the treatment of water that has an obvious contamination source, such as raw sewage. This system is not intended to

convert wastewater to microbiologically safe drinking water.

2: Operating Temperature:

3: Operating Water Pressure:

4: Maximum flow Rate:

5: Rated Capacity:

RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVAL:

Note: Depending on incoming feed water conditions replacement time frame may vary.

Description

Stage 1: Sediment:

Stage 2: Carbonblock

*All prices subject to change without notice

This system has been tested according to NSF/ANSI Standard 42 for the reduction of the substances listed below. The concentration of the indicated

substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as

specified in NSF/ANSI 42. Testing performed under standard laboratory conditions, actual performance may vary.

California Proposition 65 Warning

WARNING: this product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. (Installer:

California law requires that this warning be given to the consumer). For more information: www.wattsind.com/prop65.

Contaminant

Chlorine Taste & Odor

Particles

Questions? Contact Watts Premier