Adapta Valve Installation; Reverse Osmosis Module Mounting - Watts Premier WP-5 Installation, Operation And Maintanance Manual

Adapta Valve Installation - Part# 134007
Configuration for 3/8"
compression fittings
Step 11 Turn off the cold water supply to the faucet by turning the angle stop valve
completely off.
Step 12 Attach adapta valve as illustrated in the three photos above, choosing
the configuration that fits your plumbing. (When attaching the adapta
valve to straight pipe threads, use Teflon tape on the treads.) The green
tube from inlet side of RO module will be cut to length and attached
later in the installation.
Caution: Water supply line to the system must be from the cold water supply line only. Hot water
will severely damage your system.

Reverse Osmosis Module Mounting

Step 13 Determine best location for the RO module to be mounted to allow
for future system maintenance. The parts bag has 2 self tapping
screws. Using a phillips screwdriver, screw them into the cabinet
wall 6" apart and 16" from the bottom of the cabinet.
Note: Do not cut any RO system tubes at this time
Hot Cold
Supply Supply
Page 9
Configuration for 1/2"
compression fittings